Hyundai Ioniq (AE): Driving your vehicle / Forward Collision-Avoidance Assist (FCA) system

Hyundai Ioniq (AE) 2017-2022 Owner's Manual / Driving your vehicle / Forward Collision-Avoidance Assist (FCA) system

The Forward Collision-Avoidance Assist (FCA) System is designed to help detect and monitor the vehicle ahead or detect a pedestrian (if equipped) in the roadway through radar signals and camera recognition to warn the driver that a collision is imminent, and if necessary, apply emergency braking.

WARNING

Take the following precautions when using the Forward Collision-Avoidance Assist (FCA) System:

  • This system is only a supplemental system and it is not intended to, nor does it replace the need for extreme care and attention of the driver. The sensing range and objects detectable by the sensors are limited. Pay attention to the road conditions at all times.
  • NEVER drive too fast in accordance with the road conditions or while cornering.
  • Always drive cautiously to prevent unexpected and sudden situations from occurring. FCA does not stop the vehicle completely and is not a collision avoidance system.

The driver must be cautious in the below situations, because the system may not detect other vehicles or objects in certain circumstances. When a trailer or carrier is installed.

System setting The driver can activate the FCA by placing the Engine Start/Stop button to the ON position and by selecting: 'User Settings → Driver Assistance → Forward Collision-Avoidance Assist' The FCA deactivates, when the driver deselects the system setting.

Other information:

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Components and components location

Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Cruise Control Switch. Repair procedures

Removal1.Disconnect the negative (-) battery terminal.2.Remove the steering wheel assembly.(Refer to Steering System - "Steering Wheel")3.Remove the steering back cover (A).4.Remove the steering remote control connector (A).5.Remove the steering remote control after loosening the screws.

Categories

 
Copyright © 2025 www.hioniqae.com - 0.0162