| General Information |
| 1. | Check & Change intervals
|
Removal1.Turn the ignition switch OFF and disconnect the battery (-) terminal. 2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.
Replacement1.Turn the ignition switch OFF and disconnect the battery (-) terminal. 2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mod