Hyundai Ioniq (AE): Engine Clutch System / High voltage shut-off procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Engine Clutch System / High voltage shut-off procedures

High Voltage Shut-off Procedures
   
•
Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
•
Be sure to read and follow the "High Voltage Shut-off Procedures" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
   
•
High voltage components :
High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc.
1.
Turn the ignition switch OFF and disconnect the auxiliary (-) battery negative (-) terminal.
2.
Remove the safety plug cover (A).

3.
Unfasten the hook (A) and then remove the safety plug (C) by pulling the lever (B) to the direction of arrow.

4.
Wait for more than 5 minutes so that the capacitor in the high voltage system can be fully discharged.
5.
Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.
(1)
Remove air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air Cleaner")
(2)
Disconnect the inverter power cable (A).

   
•
Disconnect the inverter power cable as the procedures below.

(3)
Measure the voltage between the inverter (+) terminal and the inverter (-) terminal.
Less than 30V :
More than 30V : Fault on high voltage circuit

   
•
If measured more than 30V, check if the safety plug is removed completely.If measured more than 30V despite the safety plug is removed, there can be serious problems on the high voltage circuit. In this case, check DTC and never touch the high voltage system circuits.

    Safety PrecautionPrecautions To Take Before Servicing High Voltage System    â€¢ Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage.

    DescriptionTransmits or blocks the driving power of the engine when switching between the EV and HEV modes.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: In-car Sensor. Description and operation

    DescriptionThe In-car air temperature sensor is built in the heater & A/C control unit.The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and according to this signal the contr

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Repair procedures

    Inspection1.Turn the ignition switch OFF. 2.Disconnect the auto defogging connector. 3.Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0152