Hyundai Ioniq (AE): Driver AttentionThe driver must be cautious in the below situations may not work properly when recognition of the lane marker is poor or limited : / Resetting the System, System Standby

Resetting the System

  • The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets the Driver Attention Warning (DAW) system.
  • The Driver Attention Warning (DAW) system resets in the following situations.
    - The engine is turned OFF.
    - The driver unfastens the seat belt and then opens the driver's door.
    - The vehicle is stopped for more than 10 minutes.
  • The Driver Attention Warning (DAW) system operates again, when the driver restarts driving.

System Standby

Hyundai Ioniq. Resetting the System, System Standby

The Driver Attention Warning (DAW) system enters the ready status and displays the 'Standby' screen in the following situations.

- The camera does not detect the lanes.
- Driving speed remains under 40 mph (64 km/h) or over 110 mph (177 km/h).

    System setting The Driver Attention Warning (DAW) system is set to be in the OFF position, when your vehicle is first delivered to you from the factory.

    Check Driver Attention Warning (DAW) system When the warning message appears, the system is not working properly. In this case, have the vehicle inspected by an authorized HYUNDAI dealer.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation

    DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Safety ON/OFF Switch. Repair procedures

    Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).

    Categories

     
    Copyright В© 2026 www.hioniqae.com - 0.0155