Hyundai Ioniq (AE): Fuel Filler Door / Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
1.
Open the fuel filler door (A).

2.
Remove the fuel filler door pushpin (A) by turning it in a counterclockwise direction.

3.
After loosening the mounting clips, remove the fuel filler door housing (A).
   
•
When removing, pull out the packing part from inside not to damage the fuel filler door packing part.

4.
Using a screwdriver or remover, remove the fuel filler door (A).

5.
To install, reverse the removal procedure.
   
•
Make sure the fuel filler door locks / unlocks and opens / closes properly.

    Component Location 1. Fuel filler door

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Duct Sensor. Repair procedures

    Inspection1.Check that the voltage values of No. 1, 2 duct sensors change1. Sensor (+ 5V)2. Sensor groundSpecification Ambient temperature [°C (°F)] Resistance (kΩ) Voltage (V) 50 (122)1.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Intake Actuator. Repair procedures

    Inspection1.Turn the ignition switch OFF.2.Disconnect the intake actuator connector.3.Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.Verify that the intake actuator operates to the recirculation position when connected in reverse.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0127