Hyundai Ioniq (AE): Interior Features / Cargo Security Screen

Hyundai Ioniq. Cargo Security Screen

Use the cargo security screen to hide items stored in the cargo area.

To use the cargo security screen

Hyundai Ioniq. Cargo Security Screen

1. Pull the cargo security screen towards the rear of the vehicle by the handle (1).

2. Insert the guide pin into the guide (2).

NOTICE

Pull out the cargo security screen with the handle in the center to prevent the guide pin from falling out of the guide.

When the cargo security screen is not in use:

1. Pull the cargo security screen backward and up to release it from the guides.

2. The cargo security screen will automatically slide back in.

NOTICE

The cargo security screen may not automatically slide back in if the cargo security screen is not fully pulled out. Fully pull it out and then let go.

To remove the cargo security screen

Hyundai Ioniq. Cargo Security Screen

1. Push out the lower part of guide pins in both sides.

2. While pushing in one side of the guide pin, pull out the cargo security screen.

Hyundai Ioniq. Cargo Security Screen

3. Open the luggage tray and keep the cargo security screen in the tray.

    ALWAYS use the Floor Mat Anchors to attach the front floor mats to the vehicle. The anchors on the front floor carpet keep the floor mats from sliding forward.

    WARNING Carbon monoxide (CO) gas is toxic. Breathing CO can cause unconsciousness and death. Engine exhaust contains carbon monoxide which cannot be seen or smelled.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Duct Sensor. Repair procedures

    Inspection1.Check that the voltage values of No. 1, 2 duct sensors change1. Sensor (+ 5V)2. Sensor groundSpecification Ambient temperature [°C (°F)] Resistance (kΩ) Voltage (V) 50 (122)1.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).4.Disconnect the lock pin to remove the heater hose pump connector (A).

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.013