Hyundai Ioniq (AE): LCD Display Messages / Door, Hood, Liftgate, Sunroof Open

Door, Hood, Liftgate Open

Hyundai Ioniq. Door, Hood, Liftgate, Sunroof Open

This warning is displayed indicating which door, or hood, or liftgate is open.

CAUTION

Before driving the vehicle, you should confirm that the door/ hood/liftgate is fully closed. Also, check there is no door /hood/liftgate open warning light or message displayed on the instrument cluster.

Hyundai Ioniq. Door, Hood, Liftgate, Sunroof Open

If the door/liftgate open warning is blocked with another warning message, an icon will appear on the top of the LCD display.

Sunroof Open

Hyundai Ioniq. Door, Hood, Liftgate, Sunroof Open

This warning is displayed if you turn off the engine when the sunroof is open.

    Shift to P This message is displayed if you try to turn off the vehicle with the shift lever in the N (Neutral) position. At this time, the Engine Start/Stop button turns to the ACC position (If you press the Engine Start/Stop button once more, it will turn to the ON position).

    This warning light is to warn the driver the road may be icy. When the temperature on the outside temperature gauge is approximately below 40°F (4°C), the Icy Road Warning Light and Outside Temperature Gauge blinks and then illuminates.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Description and operation

    DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mod

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Parking Distance Warning (PDW) Sensor. Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the front / rear bumper cover.(Refer to Body - "Front Bumper Cover")(Refer to Body - "Rear Bumper Cover")3.Disconnect the connector (A) from the parking assist sensor.4.Remove the sensor (A) by pulling out both ends of the sensor holder.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0186