Hyundai Ioniq (AE): Heater / emperature Control Actuator. Description and operation

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Heating, Ventilation and Air Conditioning / Heater / emperature Control Actuator. Description and operation

Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.

    Components Location1. Temperature control actuator [LH]2. Temperature control actuator [RH]

    Specifications Door Position Voltage (V) Error Detecting Vent0.3 ± 0.15Low voltage : 0.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Receiver-Drier. Repair procedures

    Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Description and operation

    DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0194