Basic Service SymbolsThere are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service.
General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. • The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury.
C
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.