| Components |

| 1. Power Cable (Main) | 2. Power Cable (Inverter ↔ HSG & A/C Electric Compressor) |
Removal • Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system.
Replacement1.Disconnect the negative (-) battery terminal. 2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit") 3.Loosen the mounting screws and remove the driver's temperature control actuator (A).4.Remove the heater core cover (A) after loosening the mounting screws.
Self Diagnosis1.Self-diagnosis process. • When operating the self-diagnostics, the below fault (self-diagnostics code) will blink at 0.5 seconds interval on the temperature display settings (driver's side only) and the remaining symbols are OFF .