Hyundai Ioniq (AE): Fuel Delivery System / Fuel Pressure Sensor (FPS). Schematic diagrams
| Circuit Diagram |
| Circuit Diagram |
| Terminal Function |
|
Pin No
|
Discription
|
Connected to
|
| 1 | Fuel pressure sensor (FPS) Power supply (+5V) | Fuel Pressure Sensor (FPS) |
| 2 | Fuel pressure sensor (FPS) signal input | Fuel Pressure Sensor (FPS) |
| 3 | Fuel pressure sensor (FPS) ground (-) | Fuel Pressure Sensor (FPS) |
Specification Pressure [KPa (kgf/cm², psi)] Output Voltage (V) 50 (0.
Removal1.Turn the ignition switch OFF and disconnect the battery negative (-) cable.2.Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly")3.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Repair procedures
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Repair procedures
- Engine Mechanical System
- Hybrid Control System
- New on site
- Most important about car
