Hyundai Ioniq (AE): IMS(Integrated Memory System) / Memory power seat switch. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body Electrical System / IMS(Integrated Memory System) / Memory power seat switch. Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the memory power seat switch connector (A).

4.
Remove the memory power switch (A) after disengaging the mounting clips.

Installation
1.
Install the memory power seat control switch (IMS).
2.
Install the door trim.
3.
Connect the negative (-) battery terminal.
Inspection
1.
Remove the memory power seat connector

2.
When each switch is pressed, check the electricity flow between memory power seat switch connector and grounding, and if the electricity does not match the specification, replace the switch.

    Components

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Photo Sensor. Repair procedures

    Inspection1.Turn the ignition switch ON.2.Connect the GDS.3.Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.4.The voltage will rise with higher intensive light and reduce with lower intensive light.1. Auto light signal2.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation

    DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper

    Categories

     
    Copyright В© 2026 www.hioniqae.com - 0.0126