| Component Location |

| 1. Lumber support motor (Front/Rear) 2. Rear height motor 3. Reclining motor 4. Slide motor | 5. Front height motor 6. Reclining limit switch 7. Lumber support switch 8. Seat switch |
InspectionDiagnosis with GDS1.The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).The diagnostic system (GDS) provides the following information.
DescriptionThe auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower moto
Removal1.Disconnect the negative (-) battery terminal.2.Remove the front / rear bumper cover.(Refer to Body - "Front Bumper Cover")(Refer to Body - "Rear Bumper Cover")3.Disconnect the connector (A) from the parking assist sensor.4.Remove the sensor (A) by pulling out both ends of the sensor holder.