Hyundai Ioniq: Lighting / Welcome System
		
		
		Welcome light

Door handle lamp (if equipped)
When all the doors (and liftgate) are closed and locked, the door handle lamp 
will come on for about 15 seconds if any of the below is performed.
	- When the door unlock button is pressed on the smart key.
 
	- When the button of the outside door handle is pressed with the smart key 
	in possession.
 
	- When the vehicle is approached with the smart key in possession.
 
Headlamp and parking lamp
When the headlamp (with the lamp switch in the headlamp or AUTO position) is 
on and all doors (and trunk) are locked and closed, the parking lamp and headlamp 
will come on for 15 seconds when the door unlock button is pressed on the smart 
key.
At this time, if you press the door lock or unlock button on the smart key the 
parking lamp and headlamp will turn off immediately.
You can activate or deactivate the Welcome Light from the User Settings mode 
on the LCD display.
Interior lamp
When the interior lamp switch is in the DOOR position and all doors (and tailgate) 
are closed and locked, the room lamp will come on for 30 seconds if any of the below 
is performed.
	- When the door unlock button is pressed on the smart key.
 
	- When the button of the outside door handle is pressed.
 
At this time, if you press the door lock or unlock button, the room lamp will 
turn off immediately.
   
The luggage compartment lamp comes on when the liftgate is opened.
NOTICE
The luggage compartment lamp comes on as long as the liftgate is open. To 
prevent unnecessary charging system drain, close the liftgate securely after using 
the luggage compartment...
   
 
   
A : Wiper speed control
· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe
· LO – Low wiper speed
· HI – High wiper speed
B : Intermittent control wipe time adjustment
C :Wash with brief wipes
Windshield Wipers
Operates as follows when the Engine Start/Stop button is in the ON position...
   
 
   Other information:
   Special Service Tools
              Tool (Number and Name)
            
              Illustration
            
              Use
            09200-3N000Engine support fixture(Beam)Removal and installation of the transaxle.Use this beam (SST No. : 09200-3N000) with the supporter (SST No...
   
   Removal1.Loosen the drain plug, and drain the engine coolant. Remove the reservoir cap to help drain the coolant faster.(Refer to Cooling System - "Coolant")2.Remove the drive belt.(Refer to Timing System - "Drive Belt")3.Remove the water pump pulley (A)...