| Specification |
|
Item
|
Brake Pedal Release
|
Brake Pedal Push
| |
| Switch 1 | Max. 0.5V | Battery Voltage | |
| Switch 2 | IG OFF | Max. 50 mV | |
| IG ON | Battery Voltage | Max. 0.5V | |
|
Items
|
Specification
|
| Gap [mm (in)] | 1.0 - 2.0 (0.039 - 0.079) |
DescriptionThe Brake Switch is installed on the brake pedal and linked with the HCU and stop lamp. It sensors the status of the brake pedal (Release, Push) and transmits the signal to the HCU.
Circuit Diagram
Replacement When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.1.Disconnect the negative (-) battery terminal.2.Recover the refrigerant with a recovery / recycling / charging station.
Service Point Target Auto Calibration (SPTAC)When you need calibration :– Front view camera is removed and mounted– Replace front view camera with a new one – Windshield glass changed– Front view camera coupler of the windshield glass is deformedService Point T