| Component Location |

| 1. Horn switch 2. Horn relay (Built - in PCB Block) 3. Horn (Low) | 4. Horn (High) 5. Clock spring |
Removal1. Remove the front bumper cover.(Refer to Body - "Front Bumper Cover")2.Remove the horn after loosening the mounting the bolt.[Low Pitch Horn][High Pitch Horn]Installation1.
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Service Point Target Auto Calibration (SPTAC)When you need calibration :– Front view camera is removed and mounted– Replace front view camera with a new one – Windshield glass changed– Front view camera coupler of the windshield glass is deformedService Point T