Hyundai Ioniq (AE): Ignition System / Description and operation

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Engine Electrical System / Ignition System / Description and operation

Description
Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The ignition coil is activated, and timing is controlled.

    On-vehicle InspectionSpark test1.Check for DTCs.    â€¢ If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the tailgate lid trim.(Refer to Body - "TailGate Lid Trim")3.Disconnect the Rear view camera connector (A).4.Remove the Rear view camera assembly after loosening the mounting screws.Installation1.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Troubleshooting

    Trouble Symptom ChartsTrouble Symptom 1Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward"Surging" (repeated alternating acceleration and deceleration) occurs after settingMalfunction of the vehicle speed se

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0173