| Inspection |
| 1. | Turn ignition switch OFF. |
| 2. | Disconnect the connector of exhaust gas temperature sensors #1/#2. |
| 3. | Measure resistance between sensor signal terminal and ground terminal. |
| 4. | Check that the resistance is within the specification. Exhaust Gas Temperature Sensor [EGTS #1, #2 (T3, T4)]
|
| Removal |
| 1. | Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
| 2. | Lift the vehicle. |
| 3. | Disconnect the EGTS #1 connector (A). |
| 4. | Remove the EGTS #1 (B).
|
| 1. | Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
| 2. | Lift the vehicle. |
| 3. | Disconnect the EGTS #2 connector (A). |
| 4. | Remove the EGTS #2 (B).
|
| Installation |
|
| 1. | Install in the reverse order of removal. |
Circuit DiagramEGTS #1Harness ConnectorEGTS #2Harness Connector
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Trouble Symptom ChartsTrouble Symptom 1Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward"Surging" (repeated alternating acceleration and deceleration) occurs after settingMalfunction of the vehicle speed se