Before Jump Starting
This vehicle does not have a regular 12V battery that needs periodic replacement. It is lithium ion polymer type integrated into the HEV high voltage battery. The vehicle has a 12V battery protection system that cuts 12V battery from vehicle draw to prevent full discharge.
Using the 12V Battery Reset Switch

1. Press the 12V Battery Reset switch to reconnect the 12V battery.
2. Start the vehicle within 15 seconds of pressing the 12V Battery Reset switch.
3. After starting vehicle (
indicator
on), operate the vehicle safely outdoors in ready mode stopped and/or drive it for
30 minutes total to charge the 12V battery fully. If you do not start the vehicle
immediately after pressing the 12V Battery Reset switch, the power of 12V battery
is automatically disconnected after few seconds to save the 12V battery from additional
discharge. If the 12V battery is disconnected prior to starting the vehicle, press
the 12V Battery Reset switch again and then immediately start the vehicle as explained.
Repeated use of the 12V Battery Reset switch without a sufficient engine ON cycle (30 Min+) may cause over discharge of the 12V battery, which will prevent the vehicle from starting. If the 12V battery is over discharged to a point that the reset does not work, try to jump-start the vehicle.
Information
After starting the vehicle (
indicator
on), the 12V battery is being charged whether the engine is running or not. Although
there is no enginesound, it is unnecessary to depress the accelerator pedal.
The following items may need to be reset after the battery has been discharged or the battery has been disconnected. See chapter 3 or 4 for:
NOTICE
External power source using 12V battery
The use of external power accessories may reduce performance and function of the vehicle. Especially, the use of dash cameras may shut off the power of the vehicle prior to the dash camera's automatic shut-down.
If the power of the vehicle is shut off, start the vehicle as explained. (refer to "Using the 12V Battery Switch")
Hybrid vehicle Be sure the shift lever is in P (Park). The vehicle starts only when the shift lever is in P (Park). This vehicle does not have a regular 12V battery that needs periodic replacement.
In the event vehicle still does not have a functional 12V battery (check if interior lights will not turn on) then you can try a jump start to the engine compartment jumper terminals using a 12V booster pack or jumper cables from another vehicle's 12V battery according to the following instructions.
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).