Hybrid vehicle
CAUTION
Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.
• Check the fuel level and add fuel if necessary.
If the vehicle still does not start, have your vehicle checked by an authorized HYUNDAI dealer.
Plug-in hybrid vehicle
Do not push or pull the vehicle to start it. This could cause damage to your vehicle. See instructions for "Jump Starting" provided in this chapter.
CAUTION
Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.
• Check the fuel level and add fuel if necessary.
If the engine still does not start, have your vehicle checked by an authorized HYUNDAI dealer.
If the Engine Stalls While Driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher.
Before Jump Starting This vehicle does not have a regular 12V battery that needs periodic replacement. It is lithium ion polymer type integrated into the HEV high voltage battery.
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Self Diagnosis1.Self-diagnosis process. • When operating the self-diagnostics, the below fault (self-diagnostics code) will blink at 0.5 seconds interval on the temperature display settings (driver's side only) and the remaining symbols are OFF .