Hyundai Ioniq (AE): What to do in an emergency
- Hazard Warning Flasher
- In Case of an Emergency While Driving
- If the Vehicle will not Start
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- If the 12 Volt Battery is Discharged (Plug-In Hybrid Vehicle)
- If the Engine Overheats
- Tire Pressure Monitoring System (TPMS)
- Check Tire Pressure
- Tire Pressure Monitoring System
- Low Tire Pressure Telltale
- TPMS Malfunction Indicator
- Changing a Tire with TPMS
- If You Have a Flat Tire
- Towing
- If an Accident Occurs
The certification label is located on the driver's door sill at the center pillar and shows the maximum allowable weight of the fully loaded vehicle.
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Repair procedures
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Safety ON/OFF Switch. Repair procedures
Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Jump Starting
- Child-Protector Rear Door Locks
- Transmission Gear Oil. Repair procedures
- New on site
- Most important about car
