Hyundai Ioniq (AE): What to do in an emergency / In Case of an Emergency While Driving

If the Engine Stalls While Driving

  • Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place.
  • Turn on your hazard warning flasher.
  • Try to start the hybrid system again. If your vehicle will not start, contact an authorized HYUNDAI dealer or seek other qualified assistance.

If the Vehicle Stalls at a Crossroad or Crossing

If the vehicle stalls at a crossroad or crossing, if safe to do so, move the shift lever to the N (Neutral) position and then push the vehicle to a safe location.

If You Have a Flat Tire While Driving

If a tire goes flat while you are driving:

  • Take your foot off the accelerator pedal and let the vehicle slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off the road as this may cause loss of vehicle control resulting in an accident. When the vehicle has slowed to such a speed that it is safe to do so, brake carefully and pull off the road. Drive off the road as far as possible and park on firm, level ground. If you are on a divided highway, do not park in the median area between the two traffic lanes. • When the vehicle is stopped, press the hazard warning flasher button, move the shift lever into P (Park), and apply the parking brake, and place the Engine Start/Stop button in the OFF position.
  • Have all passengers get out of the vehicle. Be sure they all get out on the side of the vehicle that is away from traffic.
  • When changing a flat tire, follow the instructions provided later in this chapter.

    The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.

    Hybrid vehicle Be sure the shift lever is in P (Park). The vehicle starts only when the shift lever is in P (Park). This vehicle does not have a regular 12V battery that needs periodic replacement.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: PTC Heater. Repair procedures

    InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Components and components location

    Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.

    Categories

     
    Copyright © 2025 www.hioniqae.com - 0.0119