Hyundai Ioniq (AE): Heater / Mode Control Actuator. Description and operation

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator. Description and operation

Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Components Location1. Mode control actuator [LH]2. Mode control actuator [RH]

    Specifications Door position Voltage (V) Error detecting Vent0.3 ± 0.15Low voltage : 0.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).4.Disconnect the lock pin to remove the heater hose pump connector (A).

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the tailgate lid trim.(Refer to Body - "TailGate Lid Trim")3.Disconnect the Rear view camera connector (A).4.Remove the Rear view camera assembly after loosening the mounting screws.Installation1.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0159