Hyundai Ioniq (AE): Evaporative Emission Control System / Schematic diagrams

Schematic Diagram

Canister
Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set.
Purge Control Solenoid Valve (PCSV)
Purge Control Solenoid Valve (PCSV) is installed in the passage connecting canister and intake manifold. It is a duty type solenoid valve and is operated by ECM/PCM signal.
To draw the absorbed vapor into the intake manifold, the ECM/PCM will open the PCSV, otherwise the passage remains closed.
Fuel Filler Cap
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap and the fill neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

    Removal1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Remove the fuel tank.(Refer to Engine Control/Fuel System - "Fuel Tank")3.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Heater Unit. Repair procedures

    Replacement    When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.1.Disconnect the negative (-) battery terminal.2.Recover the refrigerant with a recovery / recycling / charging station.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Components and components location

    Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.

    Categories

     
    Copyright В© 2026 www.hioniqae.com - 0.0115