Hyundai Ioniq (AE): Body Electrical System / Special service tools

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body Electrical System / Special service tools

Special Service Tools
Tool (Number and name)
Illustration
Application
Correction jig for LDWS or LKAS
(09890-3V100)

Correction of LDWS (Lane Departure Warning System) or LKAS (Lane keeping assist system).
RKE Battery Checker
(09954-2P100)

Measuring the RKE battery voltage.
BSD Unit Correction Tool Set
(09958-3T500)

Used to correct the BSD unit.
Vertical Plumb
(09958-3T010)

Used to correct the BSD unit.Used to create a center line.
(Use with 09958-3T020, 09958-3T030, 09958-3T040, 09958-3T060)
Spirit Level
(09958-3T070)

Used to correct the BSD unit.Used to measure the horizontal angle.
(Use with 09958-3T080, 09958-3T090, 09958-3T120)
BSD Unit Fixing Adaptor
(09958-3T080)

Used to correct the BSD unit.Used to measure the horizontal angle.
(Use with 09958-3T070, 09958-3T090, 09958-3T120)
Digital Protractor
(09958-3T090)

Used to correct the BSD unit.Used to measure the horizontal angle.
(Use with 09958-3T070, 09958-3T080, 09958-3T120)
Digital Inclinometer
(09958-3T100)

Used to correct the BSD unit.Used to measure the vertical angle.
Case & Manual & String
(09958-3T120)

Used to correct the BSD unit to measure the horizontal angle.
Vertical Measuring Device
(09964-C1200)

Correction front view camera

    General Troubleshooting InformationBefore Troubleshooting1.Check applicable fuses in the appropriate fuse/relay box.2.Check the battery for damage, state of charge, and clean and tight connections.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: PTC Heater. Repair procedures

    InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Repair procedures

    Inspection1.Turn the ignition switch OFF. 2.Disconnect the auto defogging connector. 3.Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hioniqae.com - 0.015