Hyundai Ioniq (AE): Smart Key System / Specifications

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body Electrical System / Smart Key System / Specifications

Specifications
Smart Key Unit
Items
Specification
Rated voltage
DC 12V
Operating voltage
DC 9 - 16V
Operating temperature
-22°F to 167°F (-30°C to 75°C)
Load
Max. 4mA (When welcome light function off)

RF Receiver
Items
Specification
Frequency
433.92 Mhz
Antenna type
FSK (Frequency Shift Keying)

Smart Key Fob
Items
Specification
Battery
Lithium battery 3V 1EA
Distance
30m from vehicle, RF : 30m, Passive(LF) : 0.7m
Battery life
More than 2 years (10 times / a day)
   
•
An inappropriately disposed battery can be harmful to the environment and human health.
•
Dispose the battery according to your local law(s) or regulation.
Push buttons
3 (Door lock / unlock, Trunk)
Frequency(Rx)
125 kHz
Frequency(Tx)
433.92 MHz
Numbers
2EA

Antenna
Items
Specification
Rated voltage
DC 12V
Operating voltage
DC 9 - 16V
Operating temperature
-22°F to 167°F (-30°C to 75°C)
Frequency
125kHz
Numbers
Interior(2EA), Door(2EA), Bumper(1EA), Trunk(1EA)

    Component Location (1)1. Smart key unit (SMK)2. Interior antenna 23. Door outside handle4. Interior antenna 15. BuzzerComponent Location (2)1. Trunk open switch2.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defogging Sensor. Description and operation

    DescriptionThe auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower moto

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Warning Indicator. Repair procedures

    RemovalWarning Indicator1.Disconnect the negative (-) battery terminal.2.Remove the mirror (A).InstallationWarning Indicator1.Install the outside mirror.2.Connect the negative (-) battery terminal.Inspection1.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0111