Hyundai Ioniq (AE): Engine Clutch System / Specifications

Specifications
[Clutch Cover and Disc]
Items
Specifications
Clutch operation method
Hydraulic motor type
Clutch cover
Type
Diaphragm spring strap
Clutch disc
Type
Single dry with diaphragm
Faling diameter
(Outer × inner)
Ø225 × Ø175mm
(Ø8.8582 × Ø6.8897 in.)
Clutch disc thickness [When free]
6.4 ± 0.2 mm (0.2519 ± 0.0078 in.)

[Engine Clutch Actuator]
Items
Specifications
Operation method
BLDC Motor
Input voltage (V)
12
Max power (W)
480
Operating temperature (°C)
- 30 to 105 °C
Resistance (Ω)
120
Max pressure
43 barz

Service Standard
Items
Specifications
Clutch disc rivet depth
0.3 mm (0.0118 in.) less than

Tightening Torques
Item
N.m
kgf.m
lb-ft
Clutch cover assembly mounting bolt
11.8 - 14.7
1.2 - 1.5
8.7 - 10.8
Engine clutch actuator mounting bolt
21.6 - 26.5
2.2 - 2.7
15.9 - 19.5
Concentric slave cylinder mounting bolt
9.8 - 11.8
1.0 - 1.2
7.2 - 8.7
Hydraulic pipe bracket mounting bolt
9.8 - 11.8
1.0 - 1.2
7.2 - 8.7
Reservoir mounting bolt
21.6 - 26.5
2.2 - 2.7
15.9 - 19.5

Lubricants
Items
 Specified lubricants
 Quantity
Hybrid motor input shaft spline side
CASMOLY L9508
0.2g
Engine clutch actuator reservoir
Brake fluid DOT 3 or DOT 4
Remove air from the hydraulic line and then inject hydraulic fluid to the reservoir so that it comes between the MAX and MIN levels of the reservoir.

    DescriptionTransmits or blocks the driving power of the engine when switching between the EV and HEV modes.

    Special Service Tools Tool (Number and name) Illustration Use Clutch disc guide & adapterA: 09411-1P000 B: 09411-G2100Installation of the clutch disc.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Description and operation

    DescriptionBlcok DiagramFunctions of Front View CameraFront View Camera supports the following functions using the information (lane, light source, vehicle and pedestrian) detected by the front view camera and the vehicle's signal information (CAN communication).

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Radar Unit. Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts.    â€¢ Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.014