Hyundai Ioniq (AE): Windshield Defrosting and Defogging / To Defog Inside Windshield

Hyundai Ioniq. To Defog Inside Windshield

1. Select the desired fan speed.

2. Select the desired temperature.

3. Press the defroster button (Hyundai Ioniq. To Defog Inside Windshield).

4. The outside (fresh) air position will be selected automatically.

If the outside (fresh) air position is not selected automatically, adjust the corresponding button manually.

If the Hyundai Ioniq. To Defog Inside Windshield position is selected, lower fan speed is adjusted to a higher fan speed.

    WARNING Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility could cause an accident resulting in serious injury or death.

    To Defrost Outside Windshield 1. Set the fan speed to the highest (extreme right) position. 2. Set the temperature to the extreme hot (HI) position. 3.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: A/C Pressure Transducer. Description and operation

    DescriptionThe A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Heater Unit. Components and components location

    Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.

    Categories

     
    Copyright В© 2026 www.hioniqae.com - 0.0161