Hyundai Ioniq: Maintenance / Air Cleaner
Filter Replacement

The air cleaner filter can be cleaned for inspection using compressed air. Do
not attempt to wash or to rinse it, as water will damage the filter.
If soiled, the air cleaner filter must be replaced.

1. Loosen the air cleaner cover attaching clips and open the cover.

2. Wipe the inside of the air cleaner.
3. Replace the air cleaner filter.
4. Lock the cover with the cover attaching clips.
5. Check that the cover is firmly installed.
Information
If the vehicle is operated in extremely dusty or sandy areas, replace the
element more often than the usual recommended intervals (refer to "Maintenance Under
Severe Usage Conditions" in this chapter).
NOTICE
- Do not drive with the air cleaner filter removed. This will result in
excessive engine wear.
- When removing the air cleaner filter, be careful that dust or dirt does
not enter the air intake, or damage may result.
- Use HYUNDAI genuine parts. Use of non-genuine parts could damage the
air flow sensor.
Checking the Parking Brake
Check whether the stroke is within specification when the parking brake pedal
is depressed with 44 lb (20 kg, 196 N) of force...
Filter Inspection
The climate control air filter should be replaced according to the Maintenance
Schedule. If the vehicle is operated in severely air-polluted cities or on dusty
rough roads for a long period, it should be inspected more frequently and replaced
earlier...
Other information:
Unplug vehicle to start (Plug-in hybrid vehicle)
This message is displayed when you start the engine without unplugging the charging
cable. Unplug the charging cable, and then start the vehicle.
Remaining time (Plug-in hybrid vehicle)
This message is displayed to notify the remaining time to fully charge the battery...
Removal1.Disconnect the negative (-) battery terminal.2.Remove the roof trim assembly.(Refer to Body - "Roof Trim Assembly")3.Disconnect the roof antenna cable and connectors (A).4.Remove the roof antenna after loosening a nut (A).Installation
•
Make sure that the cables and connectors are plugged in properly...
Categories
Seat belt warning light

As a reminder to the driver, the seat belt warning light will illuminate and
warning chime will sound for approximately 6 seconds each time you place the Engine
Start/Stop button to the ON position if the seat belt is unfastened.
read more