Hyundai Ioniq: Roof Trim / Assist Handle. Repair procedures
| •
| Put on gloves to prevent hand injuries. |
|
| •
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
| •
| When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. |
| •
| Take care not to bend or scratch the trim and panels. |
|
| 1. | After lifting up the assist handle caps and loosening the mounting screws, remove the assist handle (A). 
|
| 2. | To install, reverse the removal procedure. |
Other information:
DescriptionHeated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio.The sensor must be hot in order to operate normally...
Engine Coolant Refilling and Bleeding [Drain]
•
Never remove the reservoir tank cap when the engine is hot.•
Serious scalding could be caused by hot fluid under high pressure escaping from the radiator...
Categories
Seat belt warning light
As a reminder to the driver, the seat belt warning light will illuminate and
warning chime will sound for approximately 6 seconds each time you place the Engine
Start/Stop button to the ON position if the seat belt is unfastened.
read more
