Hyundai Ioniq (AE): Crash Pad / Crash Pad Under Cover. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Under Cover. Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad under cover [RH] (A).

2.
To install, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    â€¢ When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Component Location 1. Glove box

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Components and components location

    Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Diagnosis with GDS1.REAR CORENER RADAR system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis.2.Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0197