Hyundai Ioniq (AE): Crash Pad / Crash Pad Side Cover. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Side Cover. Repair procedures

Replacement
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a remover and remove the crash pad side cover (A).
[LH]

[RH]

2.
To install, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).

    Component Location [LH]1. Crash pad side cover [LH][RH]1. Crash pad side cover [RH]

    Replacement    â€¢ Put on gloves to prevent hand injuries.    â€¢ When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Components and components location

    C

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Parking Distance Warning (PDW) Sensor. Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the front / rear bumper cover.(Refer to Body - "Front Bumper Cover")(Refer to Body - "Rear Bumper Cover")3.Disconnect the connector (A) from the parking assist sensor.4.Remove the sensor (A) by pulling out both ends of the sensor holder.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0113