Hyundai Ioniq (AE): Heater / emperature Control Actuator. Description and operation

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Heating, Ventilation and Air Conditioning / Heater / emperature Control Actuator. Description and operation

Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.

    Components Location1. Temperature control actuator [LH]2. Temperature control actuator [RH]

    Specifications Door Position Voltage (V) Error Detecting Vent0.3 ± 0.15Low voltage : 0.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Receiver-Drier. Repair procedures

    Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Smart Cruise Control (SCC) Switch. Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the steering wheel assembly.(Refer to Steering System -"Steering Wheel")3.Remove the steering back cover (A).4.Remove the steering remote control connector (A).5.Remove the steering remote control (A), after loosening the screws.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0235