Hyundai Ioniq (AE): Front Door / Front Door Belt Inside Weatherstrip. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Inside Weatherstrip. Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).

3.
To install, reverse the removal procedure.
   
•
When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame.
•
Replace any damaged clips (or pin-type retainers).

    Replacement1.Pull down the front door window glass to the lowest level by pressing the power window glass switch.2.After loosening the mounting screws, remove the front door belt outside weatherstrip (A).

    Replacement[Front door side weatherstrip]1.Loosen the front door checker (B) mounting bolt. Tightening torque : 18.6 - 28.4 N.m (1.7 - 2.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).4.Disconnect the lock pin to remove the heater hose pump connector (A).

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: High voltage shut-off procedures

    High Voltage Shut-off Procedures    â€¢ Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0124