Hyundai Ioniq: Blower / Intake Actuator. Repair procedures

Hyundai Ioniq (AE) 2017-2025 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Intake Actuator. Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the intake actuator connector.

Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

Verify that the intake actuator operates to the recirculation position when connected in reverse.

Pin NO	Function
1	-
2	-
3	Recirculated air
4	Sensor ground
5	Feedback signal
6	Sensor (+5V)
7	Fresh air

4.	Connect the intake actuator connector.

5.	Turn the ignition switch ON.

6.	Check the voltage between terminal 6 and 5.

7.	If the measured voltage is not within specification, check the operation by replacing the existing intake actuator with a new genuine part. After that, determine whether replacement of the temperature control actuator is required or not.

Diagnosis With GDS

The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).

※ The diagnostic system (GDS) provides the following information.

(1) Self diagnosis : Checking the failure code (DTC) and display.

(2) Current data : Checking the system input/output data state.

(3) Actuation test : Checking the system operation condition.

(4) Additional function : Other controlling such as he system option and zero point adjustment.

2.	Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

3.	Select the 'Current data' menu to search the current state of the input / output data. The input / output data for the sensors corresponding to the Intake Actuator can be checked.

4.	To perform compulsory operation on Intake Actuator input factors, select "ACTUATION TEST".

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly")

3.	Disconnect the connector (A) and then remove the intake actuator (B) after loosening the mounting screws.

4.	To install, reverse the removal procedure.

Intake Actuator. Specifications

Specifications Door position Voltage (V) Error detecting Recircualtion0...

Controller. Heater & A/C Control Unit (DATC)

Other information:

Hyundai Ioniq (AE) 2017-2025 Service Manual: Repair procedures

Removal1.Disconnect the negative (-) battery terminal.2.Remove the glove box.(Refer to Body - "Glove Box Upper Cover Assembly")3.Remove the smart key unit.(Refer to Body - "Smart Key Unit")4.Disconnect the body control module connectors (B).5.Remove the body control module (A) after loosening the mounting nuts...

Hyundai Ioniq (AE) 2017-2025 Service Manual: Rear Transverse Trim. Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...