Hyundai Ioniq: Engine Control/Fuel System / High voltage shut-off procedures

Hyundai Ioniq (AE) 2017-2024 Service Manual / Engine Control/Fuel System / High voltage shut-off procedures

High Voltage Shut-off Procedures
   
Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
Be sure to read and follow the "High Voltage Shut-off Procedures" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
   
High voltage components :
High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc.
1.
Turn the ignition switch OFF and disconnect the auxiliary (-) battery negative (-) terminal.
2.
Remove the safety plug cover (A).

3.
Unfasten the hook (A) and then remove the safety plug (C) by pulling the lever (B) to the direction of arrow.

4.
Wait for more than 5 minutes so that the capacitor in the high voltage system can be fully discharged.
5.
Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.
(1)
Remove air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air Cleaner")
(2)
Disconnect the inverter power cable (A).

   
Disconnect the inverter power cable as the procedures below.

(3)
Measure the voltage between the inverter (+) terminal and the inverter (-) terminal.
Less than 30V :
More than 30V : Fault on high voltage circuit

   
If measured more than 30V, check if the safety plug is removed completely.If measured more than 30V despite the safety plug is removed, there can be serious problems on the high voltage circuit. In this case, check DTC and never touch the high voltage system circuits.

    General safety information and caution

    Safety PrecautionPrecautions To Take Before Servicing High Voltage System    • Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage...

    Specifications

    SpecificationsFuel Delivery System Items Specification Fuel TankCapacity45ℓ lit. (11.8 U...

    Other information:

    Hyundai Ioniq (AE) 2017-2024 Owner's Manual: Engine Compartment Panel Fuse Replacement


    ■ Blade type fuse ■ Cartridge type fuse 1. Turn the vehicle off. 2. Turn all other switches OFF. 3. Remove the fuse panel cover by pressing the tap and pulling up. 4. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel...

    Hyundai Ioniq (AE) 2017-2024 Owner's Manual: How to Disconnect Portable Charger (ICCB: In-Cable Control Box)


    1. Hold the charging connector handle and pull it while pressing the release button (1). Information To prevent charging cable theft, the charging connector cannot be disconnected from the inlet when the doors are locked. Unlock all doors to disconnect the charging connector from the inlet...

    Categories

    Seat Belt Warning Light

    Seat belt warning light

    Hyundai Ioniq. Seat Belt Warning Light

    As a reminder to the driver, the seat belt warning light will illuminate and warning chime will sound for approximately 6 seconds each time you place the Engine Start/Stop button to the ON position if the seat belt is unfastened.

    read more


     
    Copyright © 2024 www.hioniqae.com