| Replacement |
| 1. | Remove the hood weatherstrip (A).
|
| 2. | To install, reverse the removal procedure. |
Replacement1.Using a clip remover, remove the clips and then the hood insulator pad (A). • Be careful not to scratch the hood panel.
Component Location1. Hood latch release handle
Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).4.Disconnect the lock pin to remove the heater hose pump connector (A).
DescriptionBlcok DiagramFunctions of Front View CameraFront View Camera supports the following functions using the information (lane, light source, vehicle and pedestrian) detected by the front view camera and the vehicle's signal information (CAN communication).