Hyundai Ioniq: Power Door Locks / Power Door Lock Switch. Repair procedures
Power Door Lock Switch Inspection
1. | Check for continuity between the terminals. If there is an abnormality, replace the switch. 

|
•
| Be careful not to scratch the door trim and other parts. |
•
| Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil. |
|
Driver Power Window Switch
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the front door trim. (Refer to Body - "Front Door Trim") |
3. | Remove the power window switch assembly after disengaging the mounting clips. 
|
1. | Install the power window switch assembly. |
2. | Install the front door trim after connect the connector. |
3. | Connect the negative (-) battery terminal. |
Inspection
•
Wrap the protective tape on the tool to disassemble with the screwdriver or remover. •
Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil...
Other information:
Schematic DiagramCanisterCanister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set.Purge Control Solenoid Valve (PCSV)Purge Control Solenoid Valve (PCSV) is installed in the passage connecting canister and intake manifold...
The rear seats are equipped with head restraints in all the seating positions
for the passenger's safety and comfort.
Adjusting the height up and down
To raise the head restraint:
1. Pull it up to the desired position (1).
To lower the head restraint:
1...
Categories
The front seat can be adjusted by using the levers located on the outside of
the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
Forward and rearward adjustment

read more