Hyundai Ioniq (AE): Warning and Indicator Lights / Ready Indicator. EV Mode Indicator. Service Warning Light
Ready Indicator
This indicator illuminates :
When the vehicle is ready to be driven.
- ON : Normal driving is possible.
- OFF : Normal driving is not possible, or a problem has occurred.
- Blinking : Emergency driving.
When the ready indicator goes OFF or blinks, there is a problem with the system. In this case, have your vehicle inspected by an authorized HYUNDAI dealer.
EV Mode Indicator
This indicator illuminates when the vehicle is driven by the electric motor.
Service Warning Light
This warning light illuminates :
- When you place the Engine Start/ Stop button to the ON position.
- It illuminates for approximately 3 seconds and then goes off. - When there is a problem with the hybrid vehicle control system or hardware.
When the warning light illuminates while driving, or does not go OFF after starting the vehicle, have your vehicle inspected by an authorized HYUNDAI dealer.
Information Make sure that all warning lights are OFF after starting the engine. If any light is still ON, this indicates a situation that needs attention.
Charging Cable Connection Indicator (Plug-in hybrid) This indicator illuminates in red when the charging cable is connected. Air Bag Warning Light This warning light illuminates: When you place the Engine Start/ Stop button to the ON position.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Ambient Temperature Sensor. Description and operation
DescriptionThe ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.The sensor output will be used for discharge temperature control, temperature regulation door contrl, blower m
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Safety ON/OFF Switch. Repair procedures
Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Checking the Coolant Level
- Hybrid Control System
- Engine Mechanical System
- New on site
- Most important about car
