Hyundai Ioniq (AE): Warning and Indicator Lights / Regenerative Brake, Anti-lock Brake System (ABS) Warning Lights
Regenerative Brake Warning Light
This warning light illuminates :
- When you place the Engine Start/ Stop button to the ON position.
- It illuminates for approximately 3 seconds. - When the regenerative brake does not operate and the brake does not perform well. This causes the Brake Warning light and Regenerative Brake Warning Light to illuminate simultaneously.
In this case, drive safely and have your vehicle inspected by an authorized HYUNDAI dealer.
The operation of the brake pedal may be more difficult than normal and the braking distance can increase.
Anti-lock Brake System (ABS) Warning Light
This warning light illuminates:
- When you place the Engine Start/ Stop button to the ON position.
- It illuminates for approximately 3 seconds and then goes off. - When there is a malfunction with the ABS (The normal braking system will
still be operational without the assistance of the anti-lock brake system).
In this case, have the vehicle inspected by an authorized HYUNDAI dealer.
This warning light illuminates: When you place the Engine Start/ Stop button to the ON position. - It illuminates for approximately 3 seconds. - It remains on if the parking brake is applied.
These two warning lights illuminate at the same time while driving: • When the ABS and regular brake system may not work normally. In this case, have the vehicle inspected by an authorized HYUNDAI dealer.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: A/C Pressure Transducer. Description and operation
DescriptionThe A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Front Radar Unit. Repair procedures
Removal1.Remove the front bumper.(Refer to Body - "Front Bumper")2.Disconnect the smart cruise control unit connector (A).3.Remove the smart cruise control nuit assembly (B) from thevehicle after loosening mounting bolts.Installation1.Install in the reverse order of removal.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Description and operation
- Components and components location
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- New on site
- Most important about car
