Hyundai Ioniq (AE): Hybrid Motor Cooling System / Reservoir. Components and components location
| Component location |
| 1. Reservoir 2. Hybrid drive motor 3. Hybrid starter generator (HSG) | 4. Electrical radiator 5. Electric water pump (EWP) |
Removal1.Remove the 12 V battery (-) cable.2.Remove the undercover.(Refer to Engine Mechanical System - "Engine Room Undercover".)3.Drain the coolant from the hybrid cooling system.
InspectionInverter Reservoir Cap Test1.Remove the reservoir cap and mount it on the pressure tester.2.Apply pressure of 93.16 - 122.58 kPa (0.95 - 1.25 kgf/cm², 13.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Motor. Repair procedures
Inspection1.Connect the battery voltage and check the blower motor rotation.2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.3.Replace the blower motor if it is proved that there is a problem with it.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: General safety information and caution
Safety PrecautionPrecautions To Take Before Servicing High Voltage System • Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Description and operation
- Maintenance
- DCT(Dual Clutch Transmission) System
- New on site
- Most important about car
