Hyundai Ioniq: Driver AttentionThe driver must be cautious in the below situations may not
work properly when recognition of the lane marker is poor or limited : / Resetting the System, System Standby
Resetting the System
- The last break time is set to 00:00 and the driver's attention level is
set to 5 (very attentive) when the driver resets the Driver Attention Warning
(DAW) system.
- The Driver Attention Warning (DAW) system resets in the following situations.
- The engine is turned OFF.
- The driver unfastens the seat belt and then opens the driver's door.
- The vehicle is stopped for more than 10 minutes.
- The Driver Attention Warning (DAW) system operates again, when the driver
restarts driving.
System Standby

The Driver Attention Warning (DAW) system enters the ready status and displays
the 'Standby' screen in the following situations.
- The camera does not detect the lanes.
- Driving speed remains under 40 mph (64 km/h) or over 110 mph (177 km/h).
System setting
The Driver Attention Warning (DAW) system is set to be in the OFF position,
when your vehicle is first delivered to you from the factory...
Check Driver Attention Warning (DAW) system
When the warning message appears, the system is not working properly. In this
case, have the vehicle inspected by an authorized HYUNDAI dealer...
Other information:
DescriptionContinuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load.By controlling CVVT, the valve over-lap or under-lap occurs, which makes better fuel economy and reduces exhaust gases (NOx, HC) and improves engine performance through reduction of pumping loss, internal EGR effect, improvement of combustion stability, improvement of volumetric efficiency, and increase of expansion work...
Removal[Room Lamp]1.Disconnect the negative (-) battery terminal.2.Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.
•
Put on gloves to prevent hand injuries.•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Categories
The front seat can be adjusted by using the levers located on the outside of
the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
Forward and rearward adjustment

read more