Hyundai Ioniq (AE): Electric EGR Control Valve / Specifications
| Specification |
|
Item
|
Specification
|
| Coil Resistance (Ω) | 2.37 - 2.7 |
|
Item
|
Specification
|
| Opened Voltage (V) | 0.7 - 1.3 |
| Closed Voltage (V) | 3.9 - 4.5 |
DescriptionThe Electric EGR Control Valve is installed in between the EGR cooler and the exhaust line and is a solenoid valve. This valve controls EGR (Exhaust Gas Recirculation) amount by the ECM's duty control signal depending on engine load and the need of intake air.
Signal WaveformFig.1) Duty control [EEGR Motor (-)] at deceleration or idleFig.2) Duty control [EEGR Motor (+)] at acceleration
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Heater Unit. Components and components location
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Motor. Repair procedures
Inspection1.Connect the battery voltage and check the blower motor rotation.2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.3.Replace the blower motor if it is proved that there is a problem with it.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Engine Mechanical System
- Checking the Coolant Level
- Suspension System
- New on site
- Most important about car
