| Components Location |

| 1. Brake pedal member assembly 2. Stop lamp switch 3. Brake pedal arm assembly | 4. Brake pedal pad 5. Pedal stroke sensor |
Removal[EPB None Apply]1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the rear wheel and tire (A) from the rear hub.
Schematic DiagramSystem Circuit DiagramTerminal Function Teminal Description 1IGN12Engine Control Module (ECM)3B+4Stop Lamp
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
C