Hyundai Ioniq: Cruise Control System / Troubleshooting

Trouble Symptom 2
Trouble symptom
|
Probable cause
|
Remedy
|
The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration and deceleration) occurs after setting
| Malfunction of the vehicle speed sensor circuit
| Repair the vehicle speed sensor system, or replace the part
|
Malfunction of ECM
| Check input and output signals at ECM
|
Trouble Symptom 3
Trouble symptom
|
Probable cause
|
Remedy
|
The CC system is not canceled when the brake pedal is depressed
| Damaged or disconnected wiring of the brake pedal switch
| Repair the harness or replace the brake pedal switch
|
Malfunction of the ECM signals
| Check input and output signals at ECM
|
Trouble Symptom 4
Trouble symptom
|
Probable cause
|
Remedy
|
The CC system is not canceled when the shift lever is moved to the "N" position (It is canceled, however, when the brake pedal is depressed)
| Damaged or disconnected wiring of inhibitor switch input circuit
| Repair the harness or repair or replace the inhibitor switch
|
Improper adjustment of inhibitor switch
|
Malfunction of the ECM signals
| Check input and output signals at ECM
|
Trouble Symptom 5
Trouble symptom
|
Probable cause
|
Remedy
|
Cannot decelerate (coast) by using the "SET/–" switch
| Temporary damaged or disconnected wiring of "SET/–" switch input circuit
| Repair the harness or replace the "SET/–" switch
|
Malfunction of the ECM signals
| Check input and output signals at ECM
|
Trouble Symptom 6
Trouble symptom
|
Probable cause
|
Remedy
|
Cannot accelerate or resume speed by using the "RES/+" switch
| Damaged or disconnected wiring, short circuit or "RES/+" switch input circuit
| Repair the harness or replace the "RES/+" switch
|
Malfunction of the ECM signals
| Check input and output signals at ECM
|
Trouble Symptom 7
Trouble symptom
|
Probable cause
|
Remedy
|
CC system can be set while driving at a vehicle speed of less than 40km/h (25mph), or there is no automatic cancellation at that speed
| Malfunction of the vehicle-speed sensor circuit
| Repair the vehicle speed sensor system, or replace the part
|
Malfunction of the ECM signals
| Check input and output signals at ECM
|
Trouble Symptom 8
Trouble symptom
|
Probable cause
|
Remedy
|
The cruise main switch indicator lamp does not illuminate (But CC system is normal)
| Damaged or disconnected bulb of cruise main switch indicator lamp
| Repair the harness or replace the part.
|
Harness damaged or disconnected
|
System Block DiagramComponent Parts and Function Outline
Component part
Function
Vehicle-speed sensor, ESP/ABS Control ModuleConverts vehicle speed to pulse...
Other information:
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door...
Removal and Installation1.Remove the crankshaft damper pulley.(Refer to Timing System - "Crankshaft Damper Pulley")2.Remove the front oil seal (A).3.Apply engine oil to a new oil seal lip & outer surface.
•
Remove any debris from the lip portion of the oil seal...
Categories

1. Door lock/unlock button
2. Driver position memory system
3. Side view mirror control switch
4. Central door lock switch
read more