Hyundai Ioniq (AE): Heater Hose Pump / Description and operation

Description
In ordinary cars, the mechanical water pump mounted on the engine for heating purposes is activated to circulate the cooling water, but in hybrid cars, AEWP is used to circulate the cooling water when the engine is not operating.
Classification
System
Cooling water used
Mechanical water pump
AEWP
Purpose of use
Note
(role of AEWP)
Engine
Heater
WHRS
While Engine is working
(AEWP activated)

O
O
O
On
Off
Cooling engine
(main function)
-
Heating
-
Exhaust heat recovery and WHRS cooling
-
On
Fast warm -up while cooling or heating is turned on
Increased volume of cooling water circulation
Right after engine is turned off
(EWP working)

X
O
O
Off
On
Heating
In the EV mode, the cooling water is circulated towards the heater.
Cooling the exhaust heat recovery system
During key off, the cooling is supplied for the exhaust heat recovery system

    Replacement1.Remove the battery (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.Remove the heater hose (A) and AEWP hose (B).

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Description and operation

    DescriptionRear view monitor (RVM) will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.    â€¢ This system is a supplementary function only.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the tailgate lid trim.(Refer to Body - "TailGate Lid Trim")3.Disconnect the Rear view camera connector (A).4.Remove the Rear view camera assembly after loosening the mounting screws.Installation1.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0117