| Components |

| 1. Bleed screw 2. Caliper body 3. Pad inner shim 4. Brake pad | 5. Pad return spring 6. Caliper carrier 7. Pad retainer |
Removal1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad")3.Remove the knee air bag.
Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the front wheel and tire (A) from the front hub.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the front / rear bumper cover.(Refer to Body - "Front Bumper Cover")(Refer to Body - "Rear Bumper Cover")3.Disconnect the connector (A) from the parking assist sensor.4.Remove the sensor (A) by pulling out both ends of the sensor holder.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the steering wheel assembly.(Refer to Steering System - "Steering Wheel")3.Remove the steering back cover (A).4.Remove the steering remote control connector (A).5.Remove the steering remote control after loosening the screws.