| Inspection |
| 1. | There should be continuity between the No.17 and No.16 terminals when power and ground are connected to the No.17and No.19 in the ICM-B. |
| 1. | There should be continuity between the No.6 and No.8 terminals when power and ground are connected to the No.15and No.17in the ICM-B. |
DescriptionThe ICM is united with many kinds of relays and installed over the instrument panel box.
Inspection1.Connect the battery voltage and check the blower motor rotation.2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.3.Replace the blower motor if it is proved that there is a problem with it.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the tailgate lid trim.(Refer to Body - "TailGate Lid Trim")3.Disconnect the Rear view camera connector (A).4.Remove the Rear view camera assembly after loosening the mounting screws.Installation1.