| Special Service Tools |
|
Tool (Number and Name)
|
Illustration
|
Use
|
| 09495-3K000 Band installer |
| Installation of ear type boot band |
| 09495-39100 Band installer |
| Installation of hook type boot band |
| 09568-1S100 Ball joint puller |
| Saperate the ball joint from the front axle |
| 09495-33000 Puller |
| Removal of spider assembly from a drive shaft |
Specification Engine Transaxle Joint type Max. permissible angle Outer Inner Outer Inner HEV Kappa 1.
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and steeringAdjustment or ReplaceVibartionWear, damage or bending of driveshaftReplaceDriveshaft rattle and hub serrationReplaceWear, rattle or scratching of wheel bearingReplaceShimmyDefective wheel balanceAdjustment or ReplaceDefective front suspension and steeringAdjustment or ReplaceExcessive noiseWear, damage or bending of driveshaftReplaceRattle of driveshaft and worn hub splinesReplaceWear, rattle or scoring of wheel bearingReplaceLoose hub nutAdjustment or ReplaceDefective front suspension and steeringAdjustment or Replace
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Removal • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.