Hyundai Ioniq (AE): Driveshaft and axle
- General safety information and caution
- High voltage shut-off procedures
- Specifications
- Special service tools
- Troubleshooting
- Front Axle Assembly. Front Hub / Knuckle
- Driveshaft Assembly
- Front Driveshaft. Components and components location
- Front Driveshaft. Repair procedures
- TJ Joint. Components and components location
- TJ Joint. Repair procedures
- BJ Boot. Components and components location
- BJ Boot. Repair procedures
- Rear Axle Assembly. Rear Hub - Carrier
InspectionInverter Reservoir Cap Test1.Remove the reservoir cap and mount it on the pressure tester.2.Apply pressure of 93.16 - 122.58 kPa (0.95 - 1.25 kgf/cm², 13.
Safety PrecautionPrecautions To Take Before Servicing High Voltage System • Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Repair procedures
Inspection1.Turn the ignition switch OFF. 2.Disconnect the auto defogging connector. 3.Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Troubleshooting
Trouble Symptom ChartsTrouble Symptom 1Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward"Surging" (repeated alternating acceleration and deceleration) occurs after settingMalfunction of the vehicle speed se
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Hybrid Control System
- Checking the Coolant Level
- Repair procedures
- New on site
- Most important about car
